287,292 Pages

The M549 is a High-Explosive Rocket Assisted (HERA) 155mm howitzer round developed for use by the US Military.

Development[edit | edit source]

The projectile was developed to provide extended range for standard and developmental howitzers. The projectile has two distinctive preassembled components—the high explosive warhead and the rocket motor. The warhead is fabricated from high fragmentation steel for increased effectiveness and contains a bulk-filled explosive. Currently there are two models.

Variations[edit | edit source]

The M549 contains 16 pounds of Composition B and is restricted from use with the new top Zone 8S M203 Propelling Charge. To assure compliance with safety requirements in newer weapon systems, which are capable of using the M203 Propelling Charge, a conversion to TNT fill in lieu of Composition B was introduced in September 1977 with Type Classification of the M549A1. The M549A1 contains about 15 pounds of TNT.

The 155 mm M549/M549A1 HERA is a separate-loading munition with a two-part forged shell body. The forward HE-filled shell body is constructed from high-fragmentation steel (HF1) and is of a low-drag aerodynamic profile. The rocket-motor body makes up the rear of the shell, this constructed from 4340 steel. The motor body weighs 13.5 kg (approximately 3.175 kg of which is propellant), is 266.7 mm long and is encircled by a welded overlay copper driving band and obturator band, both protected during storage and transit by a polycarbonate composition grommet. At the front of the projectile, the fuze cavity is protected during transport by an energy-absorbing lifting plug, which protects the fuze area from damage during storage, transit and handling. Before loading, the lifting plug is replaced by a fuze, and the protector cap over the rocket-motor nozzle is removed; the 155 mm M549/M549A1 HERA is not intended to be fired in the 'rocket-off' mode. On-target effects are enhanced by the shell's HF-1 steel body.The 155 mm M549 HERA forward shell body is filled with a nominal 7.26 kg of Composition B. The M549A1 HERA filler is 6.8 kg of cast TNT.At the instant of firing, the propellant gases ignite a pyrotechnic delay train in the rocket motor. The delay burns for approximately seven seconds. By the end of this seven seconds, the end of the delay train reaches the rocket's primary igniter and subsequently lights the motor's two propellant grains via an igniter pellet.[1]

Components[edit | edit source]

These projectiles consist of two major components, a warhead filled with 16 pounds of Composition B high explosive (M549) or 15 pounds of TNT high explosive (M549A1), and a solid propellant rocket motor. These components are threaded together so that the outer steel shells of both form a streamlined ogive. A supplementary charge is installed in the deep cavity of the nose. A rotating hand encircles the assembled projectile near the base. A rocket cap is threaded into the base. The cap is removed prior to firing to allow ignition of the rocket motor for extended range. The rocket motor body contains seven pounds of solid rocket propellant arranged in two segmented grains. Each of the three segments of the forward grain contains an ignition pellet. The motor nozzle is recessed in the center of the boat tail rocket motor base of the projectile, and thrust is along the longitudinal axis.

Firing[edit | edit source]

When the weapon is fired, the roating band engages the barrel rifling to impart spin to the projectile for stability in flight. The obturator and rotating band form a seal to prevent leakage of gas pressure past the projectile. Rapidly expanding gases from the burning propellant charge propel the projectile through the barrel with the velocity necessary to reach the target. Extended range is obtained through rocket assist, the rocket cap is removed prior to weapon chamberin exposing the pyrotechnic delay assembly in the base of the rocket motor. When the projectile is fired, the propellant gages ignite the delay which burns for approximately 7 seconds and then sets off the rocket ignitor to intinate the rocket motor propellent.the rocket motor burns for approximately three seconds. This additional thrust augments the velocity and consequently, the range of the projecxtile. If a PD or ET is used, the fuze detonates the supplementary charge and the supplementary charge detonates the warhead filler either on impact or the preset time.

Used with[edit | edit source]

M109, M114, M198, M777

Specifications[edit | edit source]

  • Weight as fired: 96 lbs
  • Body Material: Steel
  • Primer: M82
  • Explosive content:
  • Length 34.39inches[2]
  • Body diameter: 154.89 mm
  • Driving band diameter:
  • Fuzes (with supplemental charge):
  • Fuzes (without supplemental charge):
  • Manufacturer:
  • Range:
    • M114: 19.3 km
    • M109: 23.5 km
    • M198: 30.1 km[3]

See also[edit | edit source]

References[edit | edit source]

  • Jane's Ammunition Handbook 2003–2004

External links[edit | edit source]

This page uses Creative Commons Licensed content from Wikipedia (view authors).
Community content is available under CC-BY-SA unless otherwise noted.